Recent content by drover300tdi

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. D

    lost remote central locking and imobilized because im a pollock

    PS thanks you guys for the replies ive already had!:)
  2. D

    lost remote central locking and imobilized because im a pollock

    well this morning in the daylight and the cold! Started to check this through, found the fuse panel on the drivers side, thinking I would check all the fuses one at a time, first one I pulled fuse 1 which is a 15 amp,er, was blown! good start I thought as that was something, so after a...
  3. D

    lost remote central locking and imobilized because im a pollock

    Hi Roddyk05, thanks for reply, Just tried that but not happening for me (worth the try thanks) now ive calmed down and had a beer, thought the following would be helpful to add to help in fault finding. 1.un-locking the drivers door with the key only unlocks that door no others. 2.interior...
  4. D

    lost remote central locking and imobilized because im a pollock

    ok so I decided to charge my battery as ive not used my 300tdi very much in the last few weeks and last time I started it from cold she seemed to struggle a bit not a huge amount but as the miles is so low I decided to put it on a low charge over night. put the charge wires on to the battery...
  5. D

    Another Newbie up north! (Glasgow)

    Lol no problems, been forever since i was on here as always seem very busy! brill thing is ive done a good few miles and nothing has broken or gone wrong with my disco, so well pleased. Hope you are well and yours is still going strong!
  6. D

    2nd Gear Crunches

    errr dont that sound like a fix then?? loll
  7. D

    2nd Gear Crunches

    Sorry my mistake... hummm im from up round Parsoncross / Foxhill way. you wern't previously known as Tigger were you? I recently found out a old friend of mine is into landrovers big time there but i moved away years ago an lost contact... just wondering lol Anyhow...her indoors has pointed...
  8. D

    URGENT!!! 300tdi D1 won't start

    if head gaket gone pressure in cooling system would be from cylinders not the exhaust (but still not good) spose if bad then you will get little or no compression and so no combustion. so yes could cause this Over to more knowlageable peeps than i now as i can feel my feet off the bottom as your...
  9. D

    URGENT!!! 300tdi D1 won't start

    hi if it was running fine then look for obvious stuff first (garage guy should have done but you never know) my undertanding is that if the engine has fuel and is turning it will run, so go fuel first when investigating. check you have 12volts to the fuel shut off soliond on the injection...
  10. D

    2nd Gear Crunches

    Hi waldershelf, nothwest of sheff... dore an totley? lol spose oil could do weird things as viscosity changes? id say worth changing oil before stripping box, (even more so if not changed in a while) think norm box oil is lifed at 20K (evo1 is lifed at 40K) i WAS amazed didn't think oil would...
  11. D

    2nd Gear Crunches

    Mine was the same, thought i was gona have to do the box. However.... found out about ... Evolution1 box oil on the difflock site, replaced my box oil with it and F*** me propper amazed was better within 1/4 of a mile now 7500 miles later its brill can change gear with one finger, a friend has...
  12. D

    Hi Jimbob, can you post up (or to me) a pic of the 300tdi with the updated headlamps? ps was it...

    Hi Jimbob, can you post up (or to me) a pic of the 300tdi with the updated headlamps? ps was it worth the effort? mine are the stock headlamps that are quite poor but id rather update the head lamps than fit extra lamps! cheers for any info/comments Richard
  13. D

    What have you done to your Landie today.

    both UJ's on front prop an transfer box bolts......and nothing left over well pleased.... couldn't have done it without help on here.....was going to rip cv apart!:)
  14. D

    think my CV is buggered?

    fitted the 2 new UJ to the front prop today, as the UJ at the transfer box was nackered as per photo's i had ordered up 8 new nuts and bolts. (tops of bolts worn away) so cannot remove transfer box propshaft bolts? so had to remove output flange (3 leg puller out) tap off plate still...
Back
Top