Recent content by doriz

Can’t it be ‘Ant Anstead’, take something from the abyss of shed shiite, fettle and mig weld?

Be cheaper to fix than give away as a parts car.

What ****witery :rolleyes:

The wife and me did ours, took 10 minutes. String, Fairy and a nylon pry tool. The seal took longer to orientate.

I think there is room in the market for such product. Good luck getting it printed over here. Its not for me for the same reasons @Datatek says, however, if a 3d printed standard stereo surround could be made to replace the typically busted oem unit that would be grand.

Plus gas and map gas torch and a long 1/4 breaker bar. Good work out but very rewarding. Just be careful not to nick the cv boot rubber removing the hub retaining nuts. Use a 1/2 extension and a socket to break the rust between the hub and housing once you’ve undone them a couple of turns.

Do you not have any kids that need a volcano school project?

Suspension is behaving now it has the correct values set.

Finally swopped out the engine oil and fitted two new bump stops as they were in the to do pile. Next is to sort the brakes.

Very nice, enjoy.

A very well reasoned argument that should form the basis of anyone’s decision to upgrade to unnecessary parts 👍

Fed it fuel again.

Was that your dinner last night?

Reported :rolleyes: 🤣

The doors or you?