Recent content by debejoman

Will do cheers

Cheers my mistake 109 not 106, I thought a CB might do the trick but I will have a day trying to bleed the system first. Thanks for your advice.

Series 1 long wheel base 106 inches with slightly bigger Bore master cylinder than the 86”

Ok thanks, do you think that hid I were to change the master cylinder that using a 106” would cause any issues?

Ok cheers I will have a go at bleeding the out pipe at the servo, I don’t know the manufacturer but I will see what numbers/ I’d might be on it.

Ps I tryed useing my vacuum bleeder

Ok will have another go cheers.

Hi yes all new shoes, and the servo is new off EBay with 3/16 pipe threads I have done a similar brake referb in the past but then I used 3/16 th pipe all around with smaller - later wheel cylinders . I wondered if the existing master cylinder was letting fluid run back ?

Hi , I have replaced all the original wheel cylinders with new, as per the 1952 set up , I've also replaced the pipe work with !/4" pipe, I want to replace the original master cylinder with a series 2 two bolt fixing cylinder using a conversion kit, I have a problem !! starting with a good...