Recent content by Danny champion

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    Ha! could be a contender...! Spline looks like its worn completely smooth...
  2. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    Best of luck, hope it is just the slave...
  3. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    So, may have it sorted...(touchwood!!) Replaced the flexible hose and bled the system, problem was still there, re-tightened all the joints on the hydraulic system bled it again and everything seems ok. Woo hoo! Looking back at the whole thing I think there were several problems. The slave...
  4. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    It's odd, because there is no obvious fluid loss, no drips, and the reservoir appears full, so my thinking is with vibration and are use these cracks open up just enough for the system to suck in air
  5. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    I have ordered another flexible hose, so will fit that tomorrow night and hopefully that will be an end to it, although knowing my luck so far probably not…!
  6. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    Don't know how well you can see those small cracks… So, bled the system again this morning, and there was indeed air in it. Everything was fine for about an hour then the problem came back, checked the flexible hose it wasn't ballooning but on closer inspection the rubber has gone quite soft and...
  7. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    We checked the condition of the arm and release bearing when we had the engine and gearbox apart, all seem fine…
  8. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    Many thanks for the ideas guys, I have a friend coming over tomorrow and we'll get into it then, so hopefully I'll have news after that,a with a bit of luck a working land rover!!
  9. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    I'll give it another go tomorrow just to be sure.. Thanks for the advice I'll let you know how I get on.
  10. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    That's exactly what happens,e running nothing. engine off all gears no problem. I have replaced both slave and master cylinder and bled the system so I'm guessing it must be the clutch then...?
  11. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    When I put in the new master cylinder I made sure the adjustment was exactly the same as the old one. when that didn't work I adjusted it almost to the end of the thread for a bit more leverage and it didn't seem to make any difference...
  12. D

    Cannot select gears, tried a bunch of stuff but can't figure this out !

    Just googled it. I think that was replaced along with everything else about 10000 miles ago could I really have one through a clutch in 10000 miles? I do do a reasonable amount of towing but surely that seems excessive...?
Back
Top