Recent content by Cyn

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. C

    big vibration

    New symptom or info us that the vibration now goes away when engine is hot
  2. C

    big vibration

    Td5
  3. C

    big vibration

    Thanks much. Sorry I didn't specify I have a 2000 disco 2 TRI automatic. james
  4. C

    big vibration

    Dear Gents I am trying to locate source of major vibration. It happens at idle and smooths out around 2000rpm. It happens in N, D, 3,2,1 but in R in smoothes out again. Drives fine in all gears. I noticed what I thought was water pump noise a couple weeks back. Now it's quiet. Could a bad quiet...
  5. C

    SLS voltage diff sensors

    I believe I made mistake. When you said to test pin 1 for continuity I used pin1 on ECU not the connector. When I check the connector pin 1 I get no continuity to ground. Now what?
  6. C

    SLS voltage diff sensors

    No I found it in my 'WorkshoP Manual 1999-2003. I thought that was the same publication as Rave- guess not. Thanks for the picture. More fun to come! Thanks
  7. C

    SLS voltage diff sensors

    Awesome! Where is co391?
  8. C

    SLS voltage diff sensors

    At this point I'm confused. Can I have a recap of your thoughts?
  9. C

    SLS voltage diff sensors

    Ok There is continuity from pin 1 to frame ground. Btwn pin 1 and 2 the ohms off the scale ( I don't know how to read). From pin 1 to 3 it was much less ( like a quarter of the scale) as you can see I'm not electrical savy best I can do is follow instructions - maybe
  10. C

    SLS voltage diff sensors

    Oops wrong! There is 5 V When I connect to supply and earth
  11. C

    SLS voltage diff sensors

    Put multimeter on supply to sensor (at sensor) and there is no voltage
  12. C

    SLS voltage diff sensors

    Put continuity tester on frame and on pin 2 and it says ok. I'm not sure if I should be grounding meter somewhere else?
  13. C

    SLS voltage diff sensors

    Ok I put volt meter to both pins- 1 & 4 of 0654 at ecu -and both read 5 V. Also nano reads 5V when plug is disconnected- goes back to .02 when plugged back in. Does mean wire is bad from ECU to sensor?
  14. C

    SLS voltage diff sensors

    I can't see my last message. Anyway it said in detail that I leveled car many times and stored in ECU but as soon as I close nano or turn on ignition I hear the exhaust valve click open and lowers car
  15. C

    SLS voltage diff sensors

    Well I got it to level half a dozen times in the 'sls calibration' section, then followed instructions to save to ECU, changing different settings in 'settings'. In settings I tried 'ECU calibrated' the yes and no setting, when to 'set target values' section and put in 150. Anyway each time I...
See more
Back
Top