cornishboater's latest activity

Anyone know how to do it on a BRC multi system??

All good so far. Nothing at all to report over 6000 miles.... so I'm going to take that as a win! I kept my old LR hubs, so if you want to buy Timken bearings you can have my hubs and press the new bearings together before you start if you...

Sorry....

It has happened to me a couple of times over the years, usually using the fob a couple of times it did unlock on every occasion

That seems to be the normal nowadays, pack always less than the actual amount needed. From the ads from suppliers that use to stock these little blighters they were packs of...............1 :)

I meant the original packs sold by land rover..

Packs of 10 I think it will be

If 10 are needed then the pack probably contains 6 or 8 🙄

has anyone heard from Marty lately since he is back in NZ

+1 on that. Marty experimented creating a replacement EAS driver pack using modern solenoid hit-drop driver chips, etc. It worked, but did suffer gremlins & glitches. The plan was good, but if I remember he was too busy to complete the project.

There are limits :)

You may have a long wait 🤣

How many?

I don't think the shares will be worth much unfortunately, I am not going to be charging what they really cost, I have to take care of my fellow enthusiasts :) If any one has requests for other unavailable bits let me know, if I can do them I will

Will you be selling shares in your new enterprise?

I would also be interested in a set please if they become available, thank you.

Can't remember how many either, but yes I will probably need 20. Let us know how your guinea pig does !! LR Cat shows either 11 or 14 clips for lower trim depending on VIN.

Any one remember how many are needed, I might even contact Autoglass ;)

I cannot remember how many are needed for a full set, I would imagine probably £3:00 each plus postage. Going by what they were being sold for originally the price varied wildly toward the end of supply. So I will probably do a per unit or...

How many Keith?

Put me down for some please.

Hi Pete, without taking my trim off is 10 the quantity needed? I cant for the life of me remember now, it was quite a while back I took it off and at the moment I cant be arsed to pull it off. I have sent 10 to one of the chaps on the P38...

I have tried nylon but it was very spongy and not sharp but now that I have sorted the parameters I think I know why. The PETG is fine and is used for automotive small parts so is ok for temps and weather

Creality Ender 3 KE and PETG, took a while to get the parameters right but now seems good, I might try with nylon later

Well I finally got around to creating the CAD file and 3D printed the little rascals!

Works fine on my W11, both Rave and Adobe

I believe you do

So stepping towards the answer. Thanks for the document. Mine does drop from 1.5A to 0.7A (approx 800ma reduction) but after about 20 or 30 seconds. Not two minutes as the document suggests. Just to confirm, I pulled MF1, 4 and 5, and the...

I was going to say that too Pete, if it is as old as it looks it has done one hell of a job in a P38

Must be quite an old battery ?? Most don't have caps like that anymore ?