Recent content by clivesP38

Everything has gone back to where it came from!

Range Rover P38 4.6 HSE AUto. I am rebuilding the valve block and wondered if this is how the components should look? Or if they are broken? You can see from the photos that one has a small circle that has come out the top and the other two just have springs showing, are they ill ? Or ok...

Nice! And welcome.

Took the front right height sensor off and checked with a multimeter and all seems ok. On ohms it goes from about 1200 to 1700 without any glitches. Just the timer relay to take out overnight to see what happens. If it drops then from what you say Wammers it must be a leak. Could it be a non...

Cheers Wammers, I will look at it and report back!

Thanks for the comments guys , I soldered up the connectors behind the panels left and right inside when I first got the beast. Have done the soapy water trick. I replaced the front air bags last year when I rebuilt valve block and compressor. If the general consensus is a leak I will look...

Hi Wammers, cleared faults and started her up , fairy lights on dash and eas fault message but compressor working and went to what looks like normal height. Haven't got Nanocom, just unlock software and lead. Just plugged back in to read codes and this is what it says 2 FR signal incorrect 7...

You guys are hilarious, should be doing stand up! Thanks for the answers. Was about to order new height sensors when the old girl has dropped to the bump stops with the 35mph message. Read faults and this is what it says 2 FR signal incorrect 6 RR signal incorrect 7 Vehicle has moved 2 Cannot...

Now then, I have a 97 4.6 hse and had a similar problem. The fuel pipes above the tank had corroded and were leaking but I couldn't see it until it got so back fuel leaked onto the floor one day. Try putting your ignition on twice so the pump primes up the petrol and see if it starts on the...

320 for a good key for primer, then flatten primer with 800 or 1000 before applying paint.

Which height sensor is fr? Front right, but are you standing in front of the RR or inside? I think ir refers to the passengers front height sensor on a RHD! Anybody know?

Thanks for the reply, are you guessing that will work or is that what it is meant for? If so what are the 20 & 35 mph boxes there for?

Now then! I plugged in the EAS unlock suite to the car in an attempt to depressurise the system, instead I ended up with a " slow 35 mph max" message! Not sure how, maybe didn't exit the software properly. It is there when I put the ignition on now with the computer NOT connected. Anyway at the...

Mmmm, OK, tomorrow I will check pump is working or not first. Then move onto refurb on block. In hindsight I think I will overhaul both the pump and block. Thanks for the reply guys.

I felt silly asking where the 'how to' section was! Thought I must be missing something! Do I take it that it can only be the seals in the compresser that's gone?