Recent content by Clanforbes

Yep, probably. I'm only changing them because I'm going in so may as well do the lot.

No problem, I'll try and do a pictorial ... no promises tho 'coz I tend to forget to take pictures.

Cheers James, sounds a doddle then. I was really only concerned because everybody seems to talk about or have done the front seals/bearings but no-one seems to ever mention the rear ones (or, at least, not that I could find in all the searches I tried.) Good good, will make a start on the...

You only need to do it for the rear seal/bearing ... only thread of your's I could find was the front seal.

Thanks James ... I have most of the bits but am missing one new nut and felt washers so they are on order but when I was browsing Microcat I saw the speedo linkage and was wondering about it. BTW, did that CD-rom I sent you work out ok? Ron. Nephew has an air gun etc. and that's where I'll be...

I'm trying that already, but the difficulty I find is the various names people give to the same thing. I've already tried looking through your posts but there are so many it will take my entire holiday to find the one I'm looking for. I'm hoping the advanced search will find it. R.

got a linky?

Thanks MHM ... I was concerned about the drive for the speedo I wasn't sure if it would be a problem or not. I wanna strip all the brake drum down for cleaning anyway so job should be a good 'un then. Cheers, Ron.

Hi y'all I have seen Buster's excellent "how to" for renewing the front seal and bearing on the transfer box, but I cannot find any reference or threads on doing the rear seal and bearing. I had a new front seal fitted by local garage in August 2010 but they have retired and the new garage...

Thanks Jonlad ... I got one on order should have it by the week-end, the complete assembly that is.

Hi folks, I have searched and searched, but can't find any threads where someone has replaced the chassis mounted "Body" for the fuel filter. I can find the item in Rave (item #1 on page 264) but no mention of part number and Microcat doesn't seem to list the actual bit that bolts onto the...

You'll never need your lightweight on these runs, but it is nice to get off the beaten track.

Yep, Ive already pressed the button ... spammer didn't even try to use a different username from his ebay one ... sheeeesh :rolleyes:

LOL, been there, it was in 1976 when I could push it!

Drove it over to Grimmer's new gaff near Montrose and watched him do a better welding job than I would have ... it was worth the journey just to watch my wee 3 month old Jack Russel bitch getting to go crazy with Craig's kids and barking at a couple of ponies, she had a great time ... oh and...