Recent content by CastawayRobinson

Thanks for the info Brown. Managed to get the car to the garage today (just). Just had a call and the transfer box has eaten itself (big bits of metal coming out of it)."New" transfer box required! Just looking into options now. Is this something that goes and if so why? I have always had the...

Hi. I had a “new” gearbox fitted to my TD5 a couple of weeks ago. It was very stiff to start but the last couple of days it has bedded in and gotten much better. This week, when driving, I noticed a new noise. Thought it sounded like a rocker out of adjustment or something like that. It was...

Certainly will be from now on!

And there was me thinking that the garage would check all the fluid levels when they serviced the Landy for me! Another thing to add to my list...

Hi everyone. Thanks for the replies. Topped up and bled for now. Slave cylinder is weeping. New one to be fitted. There does not seem to be a warning light for clutch fluid. Interestingly, obviously the level has dropped enough to suck air in (as pointed out by you knowledgeable bods) but I did...

Thanks… taken the top off the cyclinder and can’t see any fluid in there! Guess I will be popping to the garage tomorrow! Something to watch out for in the future…bet they will want to change the cyclinders! Expensive hobby this

Evening Peeps, quick question for you. I was just sitting in traffic in my TD5 and went to change gear and struggled to get it out of gear. Now the clutch pedal almost reaches the floor before it works. It was fine until now. I had the gearbox rebuilt last gear and they said the clutch did not...

Hey. Not a problem...just a curiosity question. What is the actual/real reason why the half way mark on the fuel gauge is not top dead centre of the dial? My guess is the designers airing on the side of caution to gentle encourage you to fill up earlier than you would otherwise...but does...

I replaced mine with cheap ones from China and they are good. Much brighter.....but....this morning. Jumped in my 110 and turned the key and not a lot happened. Looked and voltage on the battery was about 7V. I did notice last night that the front interior light (LED) had stopped working...

Hello peeps. Hope you are all keeping well. 110 TD5 2 Questions I have a Bripart 9500 winch on the front (fitted by previous owner). It was not working but now it is (cleaning the cutoff switch). It would appear that if I use the motor to pay out the cable, then it works OK. If I pull in, it...

Hi, My TD5 110 was recently in the garage for a week with the battery out. The alarm worked fine when it when in (but the interior lights did not work). When I go it back, I changed all the door switches and the interior bulbs. Now, I cannot activate the alarm. I get 2 beeps (door open)...

Hi Peeps. 110 TD5. The interior lights were not working. I put a new bulbs in and it came on,. but it also stays on all the time when switched to door open position. I changed all the door switches and now the lights are the same but the alarm will not set (2 beeps instead of going active)...

The alarm does not go off immediately if you open a door, but sometimes goes off (I think the Ultrasonics trigger it if I forget to switch it off). Need to have a big around with a multimeter!

Hi. Not been on here for a long time. I have changed from a Freelander (1) to a 2001 TD5 110. I have a lot of opportunities with it, but the first question. How do you remove the courtesy light door switches? They are in the A, B pillar etc. Remove a screw and you can pull them but the tag for...