Recent content by Carlbrit

Managed to get it off with a 14mm spark plug socket, all sorted now👍

Hi All, I'm currently in the process of trying to remove the reverse light switch from my TD4 2006 Freelander. The question I have is how on earth are you supposed to get to the switch, so far I've taken the side cover off behind the wheel which exposes the end of the gearbox but to get to the...

Sorry about that, anyway here's the pic of one of the sides as promised, if 3d printing just remember to use mirror mode for the other side.

Pics to follow but here's the link to the STL files for you. support-plage-arriere20200221-24225-1s8o5hq.zip

I used the 3D printer at work to print the fixings for my 3 door parcel shelf, it worked a treat. Also fitted wind deflectors, I must say it looks good👍

Hi, I know it’s been a while but I’m doing this now to my 3 door. Can you help me please, I need to know how to release the end caps, also did you cut it 90mm at each end or one end 180mm ? Could you please provide a step by step if possible? Regards Carl

Hi All, I'm trying to fit a 5 door rear parcel shelf roller blind to my 2006 3 door TD4. I need the fixings that hold the roller blind in place and the fixings that hold it once pulled open. Does anyone have these lying around that they could sell to me please. Alternatively anyone have a 3...

Well what a total ball ache that was, I managed to replace the rusty fuel tank cradle with the new bars, I had to angle grind off the front 15mm nearside bolt which was just spinning as well as the old cradle itself. Then prybar in the new bars, never again will I try this, spent all weekend on...

Thanks, will have a go over the weekend,

Yeah the front passenger side bolt in the bracket, any ideas how to get it out ?

Understand what you’re saying, but I am now stumped by the 15mm bolt in fuel cradle x1 is just spinning, what’s the best way to remove this ?

So left work early to make a start, been wd40ing the x4 fuel cradle bolts all week, x3 undo but x1 is just spinning it will not undo all all so what’s the best way to get this bolt out please guys?

I'm not fitting a full cradle, I'm just going to fit the new bars either side, do I still have to drop the subframe to remove the old cradle it or will an angle grinder be ok to cut through them?

Having looked at mine the bars are so rotten I'm amazed it still there to be honest. Will have a go later, hopefully once the x2 15mm bolts each side are undone the bars will drop enough for me to cut them off. Will change them one side at a time.

Tonight I'm going to try replacing the totally rotten fuel tank cradle with just some bars instead of a complete cradle, purchased off fleabay. Question is, is this an easy job or a son of a bitch, how do I get the cradle off without dropping the rear sub frame, can I use an angle grinder to cut...