Recent content by bribeck

is this easy to do? or is it a dealer job

Where exactly is this pressure switch? cant find it in my haynes manual.

Hi guys, Thank you so much, i am going out now to check everything you have suggested. will keep you informed.

hiya peeps. right. when i turn the ignition prior to turning over, the pumps hum like a bee;, i did actually turn the key and guess what, the tank started, however, when you rev the enine you can hear the car struggling a bit, as if there is not enough fuel getting through, can one of the...

i will check that, on the motorway it was too noisy to hear anything. thank you

Thank you, will check that

my engine has cut out on me while driving on the motorway, it felt like a little juddery then all power went, i had fuel. the engine turned over without a struggle but it would not fire. maybe fuel filter, pump? anyone any ideas? would be eternally gratefull.

OMG, Talk about making things easy, ok guys thanks so much for that, good job i waited before getting the bloody drill out lol cheers

ok guys and gals, i got a 51 plate Td4, there is a sump protection plate on it, it appears once i have removed the two bolts at the back of the plastic plate i still cant remove it, after investigation and loadsa swearing i found 4 alluminium rivets? cumon, do i have to drill them out to get at...

yep you was right, took it to land rover service centre and they had a look and fixed it free of charge, wicked, just a loose screw and panel he said, thanks guys for all your guidance and comments

right ok, thank you so much for that, ill check the belt and go from there thanks brian

ok, so what do i do? any ideas

Hi, i have a freelander Td4, i needed the aircon recharged so halfords did it for me, the following day when i put the landy into reverse whith the aircon on, a terrible noise comes from under the bonnet, only to be described as a lolly pop stick flicking spokes on a wheel, if you understand...