brianp38dse's latest activity

Does the spatula clean up well in the dishwasher ?

There's a few threads on here about the "chamfer & jubilee clip" method. I chamfered mine & used three jubilee clips to compress a little. My 10ton eBay press pushed them in with no trouble. Main recommendation is to have a second pair of...

They look about brake pipe size.

What no water:rolleyes::rolleyes:

Why? Broke down? or eyeing up the gap in the fence to the pond 🤔 :p. No its never going away:D. J

sitting here 🤩

I believe they can get a hole in part of the plastic intake pipes which causes a diff in pressure which throws a fault

Normally the Wanners fill up by pushing over the center hole in the pot of grease, a bit messy but works. pull the chain and lock it then fIll.

Do you mind its not the freelander section :vb-biggrin:

As Data said leak off pipes will let air in and make it spin over awhile till it starts , had that a few times on mine.

Do the nut (5) at the far end first. It's easier while the axle end is still attached. Then undo the two marked 7 & 8 in the diagram. If the bolts are fouling on the roll-bar mounts, just undo them & let the roll-bar hang down a bit. Also do...

to remove the old ones run a drill throw the bush a couple of times towards the outside the outside of the bush is plastic

if using a press you will need the tool to do it the bushes are bigger than the hole in the arm and need pushing through a tappered tool to fit.