Recent content by brian1964

Well done! Now all the fun of renewing the oil seal! Good luck

Just found the Torque setting it's 85 lb foot so it shouldn't come off without a lot of force Good luck

Make sure the split pin is fully out before trying the big stick. I had to get a 36inch stilson on the housing and then a scaffold pipe extension on my socket bar before mine came off. I can't remember the torque setting, but I do remember that it was pretty high. If you have access to an...

Only just run in!:):)

I've had no problem with the Britpart bearings, just make sure that you pack them with grease (and then add a bit more). In a previous life I always recommended SKF bearings, no idea how expensive they are but they are one of the best. Good luck Brian