Recent content by Boston4

I replaced this part on mine - when removing the old one, the pipe was so corroded that it just snapped in half. The part number to replace is JUE108230. If you're opening the system and exposing it to air, you'll also want to replace the receiver/drier (I used this one). To do the repair...

I'm running Rotella 15W-40, which has higher ZDDP levels. I change it every 3k miles, but have about 2k until my next change is due. I'll plan to run one of the crankcase cleaners for 50 miles before the change. If it doesn't quiet down, I'll start thinking about rebuilding. Thanks for all of...

What eventually killed it? Aside from the noise, my truck is running pretty well.

Not sure about overheats. The truck runs <200F all the time. I don’t think it’s a slipped liner though, I’ve heard that and it’s quite a bit louder and more of a consistent tapping noise. Also, if I recall, the slipped liner usually occurs cold, but this sound is most apparent hot. I’ll run a...

Hi all, Curious if anyone has any input on this noise and whether it’s anything with which to be concerned. it’s an 01 V8 model with 170k

I have the same experience.

Thanks - this is really good to know! I had looked into it and was planning on swapping SLS for springs if one of the sensors dies on me.

Actually replacing them is not your issue - you jack up the truck, unplug the sensor, and undo 3 bolts. Opposite procedure to refit. Per the Workbook, you need access to TestBook to calibrate them.