Recent content by beatfreak
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
B
Didn’t accept it because it was wrong. Asked for help not a belittling by know it alls. Turns out it was a ballooning brake hose. No seals gone, no faulty master cylinder. Front hoses replaced, problem solved.
-
B
Cable break between C2527 connector and the ride height module. Spliced in a new wire, problem solved!
-
B
All valves in the front block tested successfully and continuity of all the wires tested back to the connectors under the nsf wheel arch. Will test from ecu to connectors tomorrow...
-
B
Yes I am. Replaced master cylinder, same result. Hence why I asked as I didn't want to waste money on the obvious and thought maybe it was a fault someone else had experienced. No fluid leaks anywhere else and after pumping the pedal to the floor 50 times or so which would have emptied the...
-
B
Bought one of these:
https://www.autelstore.co.uk/wholesale/autel-maxiap-ap200-bluetooth-scanner.html?gclid=CjwKCAjwzt6LBhBeEiwAbPGOgQCg-govI4ybEXzXPWTiBKb5nIogqJ0Vs4pWsK0R5Mwerh-Txyj7-hoCYGkQAvD_BwE
Does everything I need it to including suspension calibration. Fault code is C1A32-01 Front...
-
B
If that's the only difference surely with a huge amount of unassisted pressure the master cylinder would still leak? I can stand on the brake pedal for 5 minutes without the engine running and it wont budge, same if i disconnect the vacuum tube while the engine is running.
-
B
I can stand on the brake pedal with both feet with all my mite (which isnt much admittedly) with the engine off and it doesn't budge
-
B
And wouldn't it still leak with the engine off?
-
B
Seems odd it was fine before brake disc and pad change 2 hours ago now leaking?
-
B
Hi
My brake pedal is slowly moving to the floor when i press it hard with the engine on, but doesnt with the engine off. Just changed discs and pads. Any ideas?
Thanks
-
B
I can hear it letting air out so not that but thanks.
-
B
Fixed the hdc traction control and epb error by pulling fuse f30 and turning on ignition, turning back off and then replacing the fuse. All errors gone now except suspension fault. System pressures up ok but if i try to adjust the height i then get the error. Some progress at least....
-
B
just a code reader that would get the abs/hdc codes would be helpful??
-
B
Surely theres a cheaper alternative to IID or someone can lend/hire one?
-
B
Ride height needs calibrating