Recent content by bankz5152

Nothing too exciting just did a big service. All oils and filters. Engine oil, black but no bits or discolouration Front diff had a little christmas tree and a bit silvery, too be expected from an ATB after 10k. TX box clean as a whistle Rear diff, tiny christmas tree but otherwise clean...

Avoid terrafirma. They are terrible. Get OME. Need extended brakes lines. Use jubilee clips to hold your springs in. Youll need new front turret rings, 9/10 yours will sheer off.

Youre basically interrupting the fuse. Its basically the same as pulling the fuse out, just instead you have a switch inline. So it just needs a 12v source from anywhere really. Could loop it back down and into the spare fuse holder.

First pic. That one. Normal fuse goes in the top slot i think, run that to the in line fuse, switch, back to live. Nope no relay needed. Had that on my old 110 for years without any issues, and on my D2 for a couple years.

Very easy. Buy a fuse piggy back + an inline fuse. Wire the piggy back into a switch with an inline fuse. Push switch it cuts off power to the fuse and TC/ABS is off. However it will turn off ABS as well so not for road use. Turn it back on and all works again, no faults to clear. Very...

Could be a hose but seeing as they are allisport i wouldnt suspect them but ill test them anyway. No warranty over 12 months old now Cheers 😁😁

So ive got a slight inkling my Darkside intercooler may have split... Bit slow to come onto boost and in low revs/boost is coal rolling levels of smokey 😳 Its over due a service so that wont be helping either, but shouldnt be this bad! Going to devise a little boost leak checker. Will cap...

Assume its a TD5, ideally you need to plug into.some diagnostics and see why the TC fault is active. Could be many things

No difference on a 300. It will on a heavily tuned Td5 though

Wrangler. Mates got one and its brilliant. Lockers and ARB disconnects as standard on a switch. Fit 35s from stock Comfy, quiet, even has a 230v inverter built in. But 45k.... Then again how much have I spent on Land Rovers 😂😂

https://gwynlewis4x4.co.uk/product/1-polyurethane-track-rod-end-boot-single-gl1172/ Helpful arnt i 😅

Gywn lewis do new covers. Much higher quality

There is a lock washer. Gwyn Lewis has a fitting guide. Torque to spec, drive for a bit then re torque and hammer the lock washer into place.

Took a break from the usual Billing show this year and went to Hevingham Concours with Empire. Beyond incredible place. Shooting, Spitfires (yes original!), Hypercars, Supercars, JCBs and a hillclimb event! Second fasest diesel up the hill 63mph 😅 beat another well known smokey tuner buy...

The internal bar doesnt really get in the way, if you have standads seats. Its rather annoying with Corbeaus/bucket seats. As for fitting doesnt take much longer to add the internal bar and obviously considerably stronger. Chat to SD if you get a cage without the internals they should be able...