Recent content by Bakerwoodlands

Full Service History, MOT November 2012, Tax June 2012, Two previous owners. £4,495 ONO. Origional factory fitted leather and wood upgrade with sat nav. Origionally purchased in January 1998 from Park Lane Land Rover at a cost of over £59,000 of which £10,000 were extras (I have copy of original...

Full Service History, MOT November 2012, Tax June 2012, Two previous owners. £4,495 ONO. Origional factory fitted leather and wood upgrade with sat nav. Origionally purchased in January 1998 from Park Lane Land Rover at a cost of over £59,000 of which £10,000 were extras (I have copy of original...

Thanks for replies. Have set bait around engine etc and passenger footwell (and glove box as little bugger got at my werthers) but forgot about vents to rear, sound like a good place for a trap. Thanks all.

I have started to find some mice droppings along the top of the wings and scuttle, anyone had mice in their P38 before and if so did they find the nest? WIll put traps down before they do any damage but no doubt there are some common places they set up home. Thanks

I am pleased to say I have now fixed my heater problem. It was not the motors or ducting in the end but instead the small black gear that runs of the top flap mech (and which is directly driven from the servo) had moved out sufficiently to be disconnected resulting in the "foot flap" being perm...

Great advice, thanks all. Thing I can't get my head around is will direct to screen and vents as directed with no bleed by manual selection every time but not to the feet? will remove RHS panel though as may be as you say a bit of the quadrent missing or not engaging. Although thought feet were...

Thanks. Assume it must be something like this but can't understand why its the same both sides and that according to the manual all the ducts come from teh heater box so assumed some must work. As you suggest I'll take of the side panels and work my way back until I get some hot air. Thanks...

Has anyone ever had a P38 where the servo's have all tested OK and no book showing on the display, and where the temporature changes OK both sides, and where you can manually select air direction to screen and vents sucessfully BUT not to feet? The light comes on above the switch as it should...

thanks. looks like it might be a worthwile investment so do you know the best way to do this and the best place to buy it? Have seen some advertised but require OBDII socket, mine seems a bit early yo have one. Thanks again.

I have a 1998 4.6 HSE. I have no warning lights or messages showing and suspension goes up and down as it should with lights flashing to change then solid when changed etc. however I have noticed that the front off side seems the be 2-3cm lower than the near side. the whole car raises and lowers...

Thanks for replys. Did apply live and earth direct to motor after and it did same (off then on etc). Don't know what third wire is for though. Seems to be a contactor that was clicking in and out. To be fair after ordering another off e bay contacted origional provider who agreed to send another...

I have just brought a 1998 range rover 4.6 HSE. Only done 73,000 miles and seems overalll in good condition. Only thing that does not seem to work as it should is the near side head lamp wiper. After taking it out found shaft was very stiff (could not turn by hand any only just with mole grips)...