Recent content by Baileyroverq

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Baileyroverq

    P38A Transmission

    Thanks No gems isn't fly by wire it does have tps but wire from ECU could be a good shout as I cleaned underneath the car the other day maybe dislodged something will get under and have a look and get back to you
  2. Baileyroverq

    P38A Transmission

    Hi p38 4.6 Gems engine does anybody know what "invalid throttle angle data" means I have it as a gearbox fault on my nanocom Any ideas would be appreciated Thanks
  3. Baileyroverq

    P38A Transmission 4.6 hse

    Ok thanks mate I will have to give it some thought
  4. Baileyroverq

    P38A Transmission 4.6 hse

    Thanks for the replies about this but does anybody have a rough guesstimate as to what the cost could likely be to have this corrected Thanks for your help
  5. Baileyroverq

    P38A Transmission 4.6 hse

    Hi thanks I was thinking having listened to the sound it makes that with the fluid leak maybe the welds have gone on the converter as well so time for her to go out of my depth now and can't afford to get it done by someone else but great car though cheers all
  6. Baileyroverq

    P38A Transmission 4.6 hse

    Hi ok I have had a look underneath and the cooler hoses are fine but I can't see where it is leaking from I know the torque converter (basically) is like a fan that pushes the fluid around the transmission how would I check this for damage do I have to take the transmission down completely or...
  7. Baileyroverq

    P38A Transmission 4.6 hse

    Hi cooler pipes look fine but car is making a loud grinding noise as well I will have to get it cleaned off and report back
  8. Baileyroverq

    P38A Transmission 4.6 hse

    Hi all Today whilst driving home from work car started to shudder,stall,pulled over to see what was going on but then decided to find a better spot (safer) put into drive nothing happened except for rev counter moved Went through the gears still nothing tried again and it engaged anyhow pulled...
  9. Baileyroverq

    P38A Bolts

    Cheers guys
  10. Baileyroverq

    P38A Bolts

    hi does anybody know what part number the bolts that secure the ram housing to the intake manifold are have snapped 2 off managed to get them out ok but need new ones obviously any ideas would be great Thanks
  11. Baileyroverq

    P38A Rough running

    Thanks for all the info Bit wet here at the moment so no play today hopefully after work tomorrow will keep updating you on what I find
  12. Baileyroverq

    P38A Rough running

    Ah right if that's the case then shouldn't I find it with a compression test then or because it is between the 2 can it be misinterpreted
  13. Baileyroverq

    P38A Rough running

    Hi thanks for getting back where I am now is I have checked the injector wiring all gives off what you expect to see so have stripped it down removed the rail and injectors and tested them on the bench all have good spray pattern next is to try a known good injector in injector 2 cylinder which...
  14. Baileyroverq

    P38A Rough running

    Hi again I have been brought back home off the M4 today as I was just poodling along car lost all power started acting like a misfire have checked on nanocom and I have p1202 short to ground and p0202 injector circuit malfunction but at the same time short term fuel trim on bank 2 is not moving...
  15. Baileyroverq

    P38A slow to accelerate between 50 and 60 mph

    thanks everyone heavy foot at 50 it is will let her know
Back
Top