Recent content by AuDeefer110
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Took another video on the way home....
This was punching it up hill till 100kh under full load:
And this was take off at the next lights:
-
Oil fill cap doesn't blow off video doesn't show much mist from cap but check out the catch can!
-
Also would the PCV failing cause this much smoke?
-
Semi at the moment. Previously had 5w40 fully.
Is It possible my injectors are caked up or the inlet manifold is too full of oil and crap from egr?
I removed inlet pipe and oil was dribbling out of manifold.
P.s also removed intercooler and flushed it, there wasn't much oil in there. Cleaned...
-
Thanks guys, it was what I suspected. Last service i chucked in some 15w40 and yes didn't change much just smells worse than synthetic oil
-
In the last 10000k probably 2.5ltr. Most of that would be through the breather pipe. Have fitter a provent recently but hasn't had much effect.
-
Hey guys new here!!
Got a Defender td5 and she has started smoking on take off after idling at lights or extended crawling in 1st etc (Grey/Blue smoke)
Check out my youtube vid: youtu.be/fAS0sFbivaA
Has done loads of k's 320k and is blowing fumes from oil filler.
Runs and starts well no loss...
-
Hey guys new here!!
Got a Defender td5 and she has started smoking after idling at lights or extended crawling in 1st etc (grey/blue smoke).
Check out my youtube vid: youtu.be/fAS0sFbivaA
Has done loads of k's 320k and is blowing fumes from oil filler.
Runs and starts well no loss of power...
-
Hey
Hey Bankz did you re adjust the abs sensor gap.
This happened to me and I figured out I had knocked the sensor just enough to cause intermittent abs fault.
Adjustment is push all the way in till it hits the bottom. I pull it out a touch just so it doesn't damage the sensor when you start...
-
Hey
Hey Bankz did you re adjust the abs sensor gap.
This happened to me and I figured out I had knocked the sensor just enough to cause intermittent abs fault.
Adjustment is push all the way in till it hits the bottom. I pull it out a touch just so it doesn't damage the sensor when you start...