Recent content by Archimedes

Hi, sounds like your going to need a locksmith with programming gear-this will be substantially cheaper than a main dealer.Make sure you choose a reputable firm ,try the institute of certified locksmiths,or the guild of master locksmiths, whilst there was a way of reprogramming some...

Hi, some time ago I had a similar problem , turned out that the side that was heating up was ok the problem was on the other side,where, after pushing back the pistons in the caliper to accomodate the new pads one of the pistons had locked up transfering more of the 'hydraulic effort'...

Use your noggin - if youre going to do the job do it safely , use good quality equipment on a good surface--remember the golden rule --all hydraulic lifting equipment when under load will at some time- fail - gravity never will. Good quality axle stands are the bear minimum. Have a look on...

If you manage to find one that hasn't already been plated-then the chances are pretty soon it will need to be. You could start looking for one that has had this work done in recent times-by someone who knows how to weld to a decent standard,hopefully this will give you a solid disco for...

Hi- Thought I'd just say Hello and introduce myself. Recently returned to the UK after a few years in New Zealand . Been running 4x4's of various descriptions for years ,but have just picked up an old Disco 300 ,although not in too bad a condition it is going to be needing a fair bit of...