You are absolutely right, but there are a number of factors which put me off doing this:
1. The fitter is in Inverness which is 120 miles from where I live. It doesn't bother me that they'd have to make the long trip, just it is not easy for me...
Also, does anyone have a photo of which way round the spring clips go? My situation is that I had a windscreen fitted through my insurance, to find that the fitter didn't install one pillar trim correctly (none of the clips were affixed), he left...
I'm having the same issue as the original poster. But have been unable to do it after sleeping on the problem. I wouldn't part with my Disco 2, and would hate to have to replace it. But, I just cannot properly re-fit these A-pillar trims.
The...
Water does get into that spot on 3 sides -
1 condensation / leaks just above the carpet/ insulation, around the weld-point
2 in the wheelarch & partly covered by the liner, which can trap moisture-laden dirt against the joint
3 inside the engine...
Good thread and some nice welding.
I am currently trying to solve the same issue: water ingress at the outer edge of both front footwells on my Discovery 2.
On comments about the "inner wing to bulkhead area as a culprit", is this due to water...
I'm trying to locate the source of water ingress from the front of my Discovery 2 TD5. Well, I say from the front, specifically it is evident as continuously wet patches on the outer sides of both front seat carpets, but I haven't yet traced...