Recent content by Aflyingduckling
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
for hydraulic stuff I always try to go with delphi or something. Try to stay away from bp.
-
I am pretty clueless as to the name of the fittings. (I know what they look like) but I have no idea what are they called. Can you help?
-
Hi everyone,
I am currently in the process of fixing the brakes on the series :/
I need two new brake pipes. I need the pipe that goes from the flexi to the top wheel cylinder and the pipe that goes from the top cylinder to the bottom cylinder. It is for the drivers side (RHD). The book says...
-
I can send you some photos of mine if you like?
-
If I was you I'd leave it as long as possible, the seal is probably ****ed. Is yours a 3 or 5 bearing? Sometimes you can get away with leaving it which is recommended. Replacing the seal is an expensive job and doesn't always even stop the leak lol. Also have you got the wading plug in? That...
-
What age side steps are you looking for? I have a set of 4 off a series 3 in mint condition ?
-
Didn't send it on that day however did send it more recently if you are interested there is some videos on my instagram @jeffrey_the_landy.
Additionally if you are down for greenlaning at any time in Shropshire or North/Mid wales hmu I will be happy to join you so long as the old girl is...
-
Trying to find an oil leak, engine degrease. Hopefully haven't destroyed any seals :/ went a bit hard on the degreaser oops. But now when it leaks I should see where aha
-
Hi all,
hoping to get out on the lanes this weekend. Would like to try Strata Florida. I have found this route online, anyone have any opinions?
https://explore.osmaps.com/route/1224639/greenlaning--wales--strata-florida-to-machynlleth-green-lane
let me know :)
-
Ok, done for tonight now, not alot of progress to be honest used jumper cables and wired in an engine to chassis ground. Still sparking less than before tho. I think the problem is with the positive side but I am unsure. When I put the multimeter on the throttle linkage to the ground and crank...
-
Would the cable be top or bottom of Bell housing?
-
Update, still sparking. No cable seen on engine to chassis though shall put one in now
-
Thank you for the advice, I used the jump leads and tested the resistance over the ground connection (like 100 ohms!!), My positive cable is ok :). I am going to get new earth cables for both battery to chassis and chassis to starter. The battery to chassis connection is poor, it's on to the...
-
I'll give that a go and update you :) identifying the cables could be a pain :/
-
Hello everyone,
I can't remember whether I have introduced myself here but my name is Dom and I have a land rover series 3 109 station wagon, 2.25 diesel from 1982. Its very non standard as I have been slowly discovering throughout my ownership.
Anyway to the problem at hand, I started the...