Good Morning all
I thought I would post this as it might help someone. I recently gave my Series 3 cooling system an overhaul, replaced the faulty Temp sensor with a replacement and exchanged all the heater pipes and also realised the previous...
http://smithies.co.nz/land_rover/
There’s a good description in front of the series 3 workshop manual of the fittings and pipe ends
Brake pipe nuts male or female ( male screws into a female ) female nuts go onto the flexi pipes
You will have...
Agree buy a roll of 3/16 cupronickel various fittings and a brake flare tool then you’re self sufficient
If you don’t fancy that a local motor factors might make them up for you cheaply
The standard parts come straight and you've to bend to fit. A proper pain in the àrse. Especially in steel.
I have seen these come pre folded. Try Paddocks.
I make my own these days, from cupronickel, and I route from the jump hose to the...
Hi everyone,
I am currently in the process of fixing the brakes on the series :/
I need two new brake pipes. I need the pipe that goes from the flexi to the top wheel cylinder and the pipe that goes from the top cylinder to the bottom cylinder...