Anyone knows what is this resistor for?

Cant be a tune resistor, Landy is not a TD5.

Its within the wiring loom behind the dash.

Thanks.

Could be the one in the clock lighting circuit or alarm led?

Kwakerman said:

Could be the one in the clock lighting circuit or alarm led?

Click to expand...

It has the wiring for the clock but came with no clock and has no alarm either. I might have to trace it to see what it is.

Thanks for the reply.

Just looked at the wiring diagram, if it is connected to a red wire with white tracer it will be the clock lighting resistor

Or Yellow/Brown on one side and White on the other its part of the alternator charge lamp circuit (allows the alternator to work if the warning lamp fails).

Kwakerman said:

Or Yellow/Brown on one side and White on the other its part of the alternator charge lamp circuit (allows the alternator to work if the warning lamp fails).

Click to expand...

Thanks so much Mate, really cool and kind of you to research this and post answer. I will check the wiring colours tomorrow and post them here, maybe it might help someone else later on.

I think I might replace it if it's alternator related since I am in there.

Thanks again Kwakerman, much appreciated mate.


Cheers.

You can check it rather than replace it if you have a meter, should be 100 ohms +/- 5%

Kwakerman said:

Or Yellow/Brown on one side and White on the other its part of the alternator charge lamp circuit (allows the alternator to work if the warning lamp fails).

Click to expand...

Kwakerman, it's this one, you are awesome mate for looking into this.

I will check its value but since the alternator light was working it might not have had too much work to do

I have a few 1/2 watt 100 ohm resistors but the one in in the wiring might be fine.

Thanks so much again for your help and reply.

Cheers Mate.

No probs, you will need to pull the bulb to check it as the bulb is in parallel with it.

Kwakerman said:

No probs, you will need to pull the bulb to check it as the bulb is in parallel with it.

Click to expand...

Thanks Mate, that way it will isolate the resistor. You are a super guy, thanks again.

Looking forward to more cross posts with you on the forums. Feel free to comment on my threads always. I will be doing quite a bit of practical performance stuff to the Landy, hope to see you around.

Cheers mate and thanks so much.