Latest activity

All's I have is a electric car tire pump 😂 either that or no car

That's on my icarsoft cr max , not the easunlock software

the emergency valves seem good , getting air back into the system is going to be my issue, the air lines that go into the compressor box , would it be possible to put an air fittin on that and fill it up with a tire pump?

CR Max does not do most stuff on a P38. Petrol Engine & possibly gearbox only. You need Nanocom or EASunlock V3 If your EAS is on the bumpstops, there's no air in it & no need to deflate. Simply push the collets in & pull the airlines out...

Quiksteel didn't work. Close but plastic just deforms. Drill the RHS one and that was enough to wedge a punch in there and undo the bolt from the remains of the nut. Tried the same trick on the other side, rust dropping in my eyes, ears, hair...

Depending on where you are in the country. This was in wales for 3 days He drags his trailer round a few lanes till we dump it on a campsite.

The good news is that slooby's rangie runs. Other news on other thread!

If you're offended by words like "kiddo", or the other sentences in Mark's initial post, then you definitely need to man up. There was definitely absolutely nothing in there that was offensive, racist, abusive or otherwise !! It's called...

Its melting outside we have peeps coming at 5 for drinks then I'll get the bbq fired up. I think its too hot to sit out got a big fan going in the living living room to keep the dogs cool, they have a pool outside as well. :)

Tempting fate lad😱😝

As for once the air bags are back on , how do I fill the air bags Without the software? Is it a case of you just run the vehicle?

Something I would like to try been honest, plan is take wife and our dog ideally stay somewhere overnight is well. Could do with getting some AT tyres as currently sitting on normal ones and not sure I would want to chance it unless there is...

Plugged my icarsoft in , went onto air suspension and keeps coming up not support for vehicle

Gorra 1.5L plastic bottle ov water int freezer to make me drinks. Never leave it in long enuff to freeze. Just go cold and form a bit ov ice round the inside. When cold it goes int fridge. Tis quiet outside. Good to see peeps taking up the...

I will say with the land rover compared to BMW, we have working indicators!!! lol. If all you drive is towing across a field and some road driving, what about a … toyo.. I can’t say it… Toyot … oh my this is difficult to say….. Toyota? LOL! Rav...

I have an icarsoft cr max , I downloaded the classic range rover version but I couldn't get it to open. Do you need winrar to open it or something? I have the leads for the OBD2 port if that's what u mean?

It was a case of climbing inside the boot from the seating area to remove as much of the back door trim as possible, just enough to get my hand in the reach the lock actuator and pull the slider part down. The boot door door panel had to be...

Not seen that one on the duty free aftershave counter :p

Today I took W to the airport for her first trip to Blighty. Got there in plenty of time. Got back 45 mins later so at about 13:30. She was still in the airport at 1600hrs. Flipping Ryan hair. She said apparently the plane never fully left...

How did you deflate the air suspension? (For future reference) I Searched online and found people talking about easunlock , but it seems you have to pay for the P38 version. Is there a way to manually deflate them without just getting angry...

It works if I connect two wires, positive and load to the two terminals. So I am happy with that.

I will leave England for somewhere else in Europe and I have three dogs so I will need to drive to my new home. I will take my current car there and wreck it. Unless somebody wants to come and buy the car from me and drive the car back to...

And I said many times that I will be running the car with very little load.

I have fixed 2 minor faults on the Mini today. :) L-Turn tell-tale on the dash was not working. Took the whole cluster out and checked the bulb which was OK. I cleaned the copper track and tweaked the bulb-holder spring contacts and it all...

Last thing to do before stripping the dashboard: Cubby box. Need to buy a 10mm metal drill for that. But first, a beer!

Last week, when a friend was servicing my 2012 FL2, i noticed seeing daylight at bottom of airbox. I dont remember seeing the hole when i fitted a K&N panel filter six months ago so i know it must have been in place then atleast. I bought a...

I have the o-rings and I will tell you how it goes when I do it. On the seal I contacted a distributor of SKF and they think that they can help me. I am waiting to hear back from them next week before I do the work on the car.

All I am saying is that the ZF 8 speed gearbox is not optimized for British speeds. Yes it is used by many manufacturers but it is made in Germany and they will have considered the autobahn. Anyway I'm not really concerned about this because my...

I didn't want to know the answer to my question, I was just pointing out that a question can be worded in a way to be an insult to somebody. Given all of the insults that I've had here I just assumed it was another one. If you wanted to ask...