Another good thing about the Stable matting is that the dimples on the under side mean that air can circulate between the metalwork and rubber, keeping things dry. Easy and cheap to do, hard wearing, good sound proofing. No downside at all.
Soz about that. It sounds tiny but the inside of your urethra isn't wide!
I totally understand why you ain't getting anything done.
A friend of mine had to have part of his urethra replaced with summat, I don't know what. And when all that...
High prices can sometimes be a bit "interesting". We try to avoid holiday times on our ferry bookings but cannot avoid September which is often higher than you'd think due to so many crumblies going abroad after the school hols.
When we came...
Finally continuing with my plan from a couple of weeks back and managed to nip out on to the driveway and change the oil in the rear diff this evening. No record of it being done but that's not to say it hasn't at some point. This could...
Has anyone got a pair of the S3 bonnet latch hook things in the spares pile. There are plenty of new ones about, I’m looking for a ratty old galv set with 6 layers of worn paint.
That would polish up pretty good I should think, good enough anyway.
Where would you stop though?
Once the bodywork is done, then it's the interior, then the engine etc
Yes, all the panels are original as is what's left of the paintwork which has gone very matte over the years. Some folks value originality and bang on about 'patina' but I certainly don't. If I bought it, I'd have to get it repainted and...
There are different pads and pins for 110, you need the others by the sounds of it.
Along with calipers and discs.
I had the same problem with my 90 which has 110 brakes on the back.
Essentially one set of pads are thicker, the later ones I think...
I’m new to Freelander 2 ownership, but I’ve been active in forums since they first appeared on the Internet. Initially, forums were the digital successors to old-school car clubs—where you'd elect a board, pay a membership fee, read a magazine...
I assume that this image is the lip seal, which appears to be corrupted in your example.
I assume that there is no way to buy this from anyone, unless you can suggest a supplier?
I found possible o-ring suppliers for the sizes that you...
Was filling me water can to nite when a squirrel jumped oft me fence onto the garage by me. Dunt fink he knew eye were there. He sat ont roof watching me watering. Eye moved down the bottom ov the garden and
The chassis itself is fine as it was replaced about 2 years ago. Bulkhead's been repaired. It's been through the IOM equivalent of an MOT and is road legal currently. Engine's sweet; gearbox is fine. A couple of swinging arms could do with...
When it comes to value of older landy's a lot depends on the condition of the chassis and bulkhead, at least it does to those who know them. I presume IOM has MOT's ? Can history be checked?