Latest activity

Can't find an easily available one. Just watching an excellent section of the Monte Carlo in the snow loads of classic cars!

I do not swing my dear friend but if if Lara Croft would turn up with it id make a new film called womb raider. :p

Smooth auld dog ye ;)

I wonder if it is available with subtitles? Obvs I didn't even look for that. 🙄

He's just crashed at Le Mans. 😱

Tomb-Raider? You going to swing the other way then?🤣🤣🤣🤣

I did have some lovely cherry wood, think all ive got left is oak.

This is very likely if there is no slack in the throttle cable.

By a strange sequence of circumstances I am currently watching a film on my pooter. Never done this afore. "Un homme et une femme" with the gorgeous Anouk Aimee and Jean-Louis Trintignant. He knew his way around fast cars. The film won a stack...

I already changed the spark and lead with new ones on cylinder 1 , still have exactly same roughness and rotten egg smell. so next step if it not a faulty coil will be compression and injector test, right? my previous data reading were made at...

@DevonGuy glad to see you is up and running!!

We do have some fruit tree wood, I'll give it a whirl.

I am still surprised at the number of D1 s I see over here. D2s are much rarer. But then it is warm and dry a lot of the time and any car over 20 years old doesn't have to pass their MOT!

thanks, I will make some check. just in case I am preparing some spare injector Bosch 0280155787 is the correct part? is it possible that the cause of the roughness in cylinder 1 detected by the ecu was actually provoked by an other cylinder...

A girl I shared a house with in Devon, who ended up with first in mechanical engineering explained to me how humid conditions lead to a better burn. I had a car with an SU carb at the time which always ran better in such conditions as you...

Does anyone know how I would find out which relay is which on my 1986 Ninety 200TDi. I know the one on the extreme left is the starter relay and the one on extreme right is the hazard relay. Thanks

It's probably the green fuel pipe which rubs against the wiring loom for the pump. Known TD5 issue so that's where I'd look first. The replacement line is available on its own (YNI500030K), it's easy to replace and doesn't need the tank dropping...

If it’s directly from where top of fuel pump is, check the hoses going to fuel pump and make sure connection is good into the pump and if they’re ok then check each line for rub through. when do you see this leak, engine running or constant leak...

Hi everyone, My disco 2 td5 2004 start to leak fuel yesterday. It seems that is pretty serious one just above the tank. I will send a video (not so good, sorry). Where do you think i should start looking?

Ok so the tabs the misses is taking has made her off head......:oops: . . . . . . . . . . . . She has given me her bank card & told me to buy myself somit. 🤣🤣 Quite fancy this..........

Topped up power steering with speshull Land Rover green stuff from a Landy place.

that’s exactly my thoughts unless it’s been welded but it’s just chasing the worm really. I don’t see any d2’s around here at all now, 2023 I saw two but I checked the reg plates last year as remembered them and they’ve been scrapped.. ironically...

I used the cheapest sound pads from Ebay and they worked just fine. I then used a foam insulation from Vandalised, that also worked fine. Dodo is too expensive in my mind. Sound pads on the inside of the door skins and foam inside the door inner...

Thanks again I'll check on the (P) bulb first. I am sure I changed all the dash bulbs when I had it in bits doing the Bulkhead, Not every holder had a Bulb as I remember. The (!) Brake light is for low level on mine and does work.

You sure he didnt sing that..

Glad to hear your back doing stuff, mind yer dont over do it. Youd need a wet suit & flippers to do yer garden here its been lashing for days.

After a good clean up just found out that I’ve got a r380 box, result. Gearbox attached and painted, I’ve fitted the bulkhead again with YRM stainless bolt kits. New chassis loom from Autosprarks installed and clipped to the rear chassis cross...

Loads of all of the above here but all parked up as projects in driveways. I got offered a D3 last week for 250 sovs needs a sill welded & the starter live rewired. Got new nobby tyres on it so he just wants the sale price of the tyres.

Above 10c & thats our summer. :D

Had mine from new landrover military sales spent a day at the factory watching it being made a real fun day lots of banter 👍