Latest activity

Sure, let me copy and paste here..... DIAGNOSTIC 1 DIAGNOSTIC 2 DIAGNOSTIC 3 MESSAGE B1030 B1030 B1030 LEFT FRONT SEAT HEATER B1032 B1032 B1032 RIGHT FRONT SEAT HEATER B105A B105A B105A CABIN TEMPERATURE SENSOR FAN SHORT...

I agree. Spreading jam on top of cream is nigh-on impossible

Welcome back!

Hi and welcome!

Does the 4WD switch work ? I'm sure mine wasn't wound in that far (i could be wrong .... yours maybe shorter too). There's only one wire to it to so I ran a short strap to the bolt that's almost hidden behind you super-stud.

Think we will do that next time.

Yes I know but it worked for me..

I may have replied earlier, but bypassing the mechanical lift pump and fitting a Facet copy one off of ebay works well.

Dont think the threads have anything to do with the union seal, that is on the end of the pipe.

It’s already mapped

Definitely not a roar on start up, actually come to think of it, it was roaring on startup….but now not…start vehicle and the fan is operating very quietly all the time.. I’ll do the newspaper test and get sniff test..

I don’t follow?

I'm still struggling with this issue. I had a diagnostic done and attach the list of faults. They did it 3 times and managed to clear only 3 faults, the rest were constant. I made a list of what they were.

Morning All. :D Not a bad day it seems. :) A shopping day. :( Have a good day. :D

@Nodge68 @kernowsvenski

Thanks Stanleysteamer I will be using extra rtv this time!!!

Smaller but necessary jobs, fitting into the policy of "as it comes off its sorted" and some new brackets being made: Intercooler bracket (above) with a fit check (below). The rear body panels threw a small curve ball. Turns out there was a...

So remove it and leave the 2 in front on??

There must be an algorithm based on serial number. Who wants to try to derive it!?!?!?

🤣 🤣 🤣

On another note, it ran spot on up until yesterday where I replaced the leak off pipes and the nylon fuel pipes from lift pump to filter, filter to lift pump. I should have stuck to if it ain’t broke don’t fix it 🥲

I’ll give that a go next time I’m on it I’ve noticed that the lift pumps seem to get worse and then occasionally you get a good one which is why I’m just going to bypass it next time. PTFE tape on the threads is a good idea I shall be doing...