I'm not worried. The jack could take the weight of the car and the trailer but if it was awkward I could drive the Pluriel off. I have had a good look around it and there are serious chassis members which could be jacked on. With my other big box...
Just had another look, drip seems to stop when the engine is off, but starts again when engine is running and getting up to temp/pressure. Coolant level looks good in overflow. Didn't have this problem before today - possible that refitting the...
So - I've confirmed voltage at idle is 12-12.6 or so. When revved, this goes up to around 13-14. This likely to be contributary?
Really not looking forward to replacing the alternator if required - I understand this is a rad out job!
Hi I’m getting a heated windscreen fitted to my 03 Discovery 2 next month and need to get switch and relay and 2 40amp fuses
Anyone know where I’d get switch and relay
I’ve looked on eBay but there all grey for pre facelift models
So l have been offered a good deal on a late model Puma 110 XS.
I realise this is a "Commercial Vehicle" in the eyes of DVLA but not HMRC.
l've read that you can put it through a business anyway (l wouldn't be claiming VAT as not registered)...
Hello everyone
We have recently just completed a cambelt and water pump change on my discovery 3 2.7 tdv6, now we had an issue where the cams moved and when we put the belt on it locked up when turning over by hand.
So we took everything off...
Can you Jack it with the pluriel on the back ? I would think you would have to unhitch it from the Disco ! To get the hight , you need to do a dummy run
For peace of mind , I would be thinking about it for the entire trip 😟😟😟
Got the injectors out today. 1,3 & 4 popped out fairly easily with a flat bar on the plastic cover to support my pry-bar.
Number-2 needed my slide hammer pictured above, but eventually came out. Took all the tips off, and cleaned them out so...
Hi guys.
Thought I’d pick up this old thread and see if we can’t get a conclusion as I have the same issue as the OP.
I replaced both rear driveshafts about a year ago and it threw up the 3 amigos. I was busy and ignored it but now...
LOL, no probs, anything EV related is OK for here.
On that note I needed to make a small adjustment to one of the cells in the pack.
I'm not sure why but the last few times I checked my BMS I noticed cell 89 had drifted a bit low so decided to...
My pressure gauge arrived with a bsp to M12 x 1.5 adaptor which allows it to fit the injector end of the fuel pipes or in place of the fuel rail pressure sensor.
All good and in excess of 6,000 psi when cranking.
Now with an injector out and...
I have a 2002 freelander td4
I have a knocking from the front, which I think is either driveshafts or top mounts. I have checked bottom arms a drop links
I have put a video showing the driveshafts have play. But is this normal or not.
Could you...
I removed the radio as I couldn't hear it 😄
Can't see me putting one back in unless I change the engine or massively soundproof the vehicle (neither of which will happen).
Pete
Is it a special application?
The number of standard trailer kits I've fitted there's never been a live pin 🤔 the only live for most modern kits I've fitted have been for the control module along with its own earth👍
Unless your talking about the...