Wheel stud pulled out

Hello all,

one of the front wheel studs has pulled out and in the process has ruined the thread.

What’s the best remedy for this now?
Is there any recommendations on recapping the thread and to what size and then what size studs do I go for?

It’s the screw type on a 1963 Series 2A.

Thanks,
Richard

Drill out the threaded hole in the hub to 9/16 and drive in some splined knock in studs.
Cannot remember the part number needed, but a few minutes on google should find them.

I think this is them, but please check first, https://www.ebay.co.uk/itm/29343901...rmXd/Zq51N4O3WDfm6WELN5zs=|tkp:Bk9SR8K47OLnYQ

Iirc there is a little bit if grinding needed on the hub for the stud to fit nicely, just a nick nothing scary.

I've had the same problem occur. Yarmite, how did your repair go?