transmission doesn't look like its sat right

I have dropped my engine out because of all the issues. figured id strip it as its really an unknown. as i was removing the bolts from the bell housing i looked at the transmission and it looks like its sat too far back, either that or the mounts are wrong.

The reason i think this is because the bolts that go through the bracket and rubber bushes are on quite an angle. (will try get a picture)

I'm wondering why, if its normal. first thoughts are that someones welded the brackets on wrong. or that its just moved forwards as i have pulled the engine???

any thoughts?

can i refer you to range rover section...very first sticky..

then try again...

Sorry

its a G reg 90 with a v8 that i have just bobbed out.