- Posts
- 10,639
- Location
- Oxfordshire
i don't think you followed what i said
you would have two threads.
- a locked down guide
- an open discussion thread about the guide
just an idea, might be a naff one!
Feature Request technical sections moderation
- Thread starter blue beasty
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
you would have two threads.
just an idea, might be a naff one!
- Posts
- 58,170
- Location
- Preston Lancs.
Did you spend your honeymoon stood up in a canoe?
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,124
- Location
- Gloucestercotshirewolds
A bit of history for those that don't know.
All threads posted in what is now called the technical archive are auto moderated.
A section was created in the Secure Unit to discuss and vote of whether a guide made the grade before approval but they was very little input.
Since then I've mostly been asking those I trust with the relevant knowledge to check them over before approval.
It would be very helpful if anyone feels bad advice or examples is given in any of the approved threads to report it so it can be addressed.
All threads posted in what is now called the technical archive are auto moderated.
A section was created in the Secure Unit to discuss and vote of whether a guide made the grade before approval but they was very little input.
Since then I've mostly been asking those I trust with the relevant knowledge to check them over before approval.
It would be very helpful if anyone feels bad advice or examples is given in any of the approved threads to report it so it can be addressed.
Antichrist
Member
- Posts
- 59
- Location
- Georgia, US & Alnwick sometimes
You almost nailed it.
Rather than putting more work on the mods, the tech article creator could (be required to?) also post a "feedback/questions/corrections" thread in the appropriate forum and link to it in the tech article (being sure they are subscribed to the feedback thread) and include a note in the tech article that followups should be posted there. Then the tech article OP can read the replies and edit their own tech article as needed.
Only if the tech article contains incorrect info that the OP doesn't correct should it then be reported to the mods to deal with.
hoopfish
Well-Known Member
- Posts
- 2,616
- Location
- East Sussex
Maybe if you followed the knock the pump about until engine barks then tap back until it stops crap.
Ah shoot......i didn't do the tap back bit, now what did i do with that hammer?
- Posts
- 10,639
- Location
- Oxfordshire
- Posts
- 58,170
- Location
- Preston Lancs.
Pump timing on an old Disco is done by setting 1.54 mm lift on the cam at TDC. New pumps can be set with the timing pin, old ones with internal wear need to be set with a DTI.
- Posts
- 10,639
- Location
- Oxfordshire
You almost nailed it.
Rather than putting more work on the mods, the tech article creator could (be required to?) also post a "feedback/questions/corrections" thread in the appropriate forum and link to it in the tech article (being sure they are subscribed to the feedback thread) and include a note in the tech article that followups should be posted there. Then the tech article OP can read the replies and edit their own tech article as needed.
Only if the tech article contains incorrect info that the OP doesn't correct should it then be reported to the mods to deal with.
ideally, that would be great
however, afaik the tech articles have to be screened and moved by a mod to the correct section.
I'd also lock the creation of threads in a 'discussion section' else you'll get umpteen new threads on the same article, so the OP won't be able to create one.
i can also see a problem of issues being unreported as people will give the OP a month to fix it.. then forget about it
reducing mods work would definitely be a plus. any more thoughts?
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,124
- Location
- Gloucestercotshirewolds
As I see it any open thread will generate discussion, disagreement and get side tracked.
They will get longer which will generate more questions as folk get confused and, frankly, too lazy to read it all (a dozen or so new threads asking questions get posted every month despite DO NOT POST QUESTIONS being pasted everywhere)
Guides should be as clear and concise as possible and preferably with one author so any changes can be easily agreed.
Any disagreements about them can be discussed in the open forum and reported for mods to make a decision to remove/edit/add to.
This was all supposed to happen in the Secure Unit before approval but it just didn't work
They will get longer which will generate more questions as folk get confused and, frankly, too lazy to read it all (a dozen or so new threads asking questions get posted every month despite DO NOT POST QUESTIONS being pasted everywhere)
Guides should be as clear and concise as possible and preferably with one author so any changes can be easily agreed.
Any disagreements about them can be discussed in the open forum and reported for mods to make a decision to remove/edit/add to.
This was all supposed to happen in the Secure Unit before approval but it just didn't work
- Posts
- 10,639
- Location
- Oxfordshire
i think it's going to be a case of suck it and see. make changes if it doesn't work out
Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
Told the Doris that last night,i think it's going to be a case of suck it and see. make changes if it doesn't work out
and no changes needed to be made
