Landrover63
New Member
- Posts
- 1
- Location
- Leicester
Hi all
This RRS has only one code, P140A: EGR C, and low power, however the boost/manifold pressure sensor is reading 16 kPa. Generically this value should be either 0 kPa (if ref to absolute pressure), or approx 100 kPa with koeo i.e. atmospheric pressure.
The question's are...
a) has any one seen this or similar very low pressure reading before partic. with just key on and engine not running.
b) does any one have the web address for Landrover technical where I can get wiring diagrams and component locations.
I have fitted a new, genuine manifold/boost pressure sensor, reading changed from 15 to 16 kPa. Voltage at sensor plug is 4.9v with zero vaults on other 2 wires. Not too concerned about P140A at the moment.
Any help with the above would be greatly appreciated.
This RRS has only one code, P140A: EGR C, and low power, however the boost/manifold pressure sensor is reading 16 kPa. Generically this value should be either 0 kPa (if ref to absolute pressure), or approx 100 kPa with koeo i.e. atmospheric pressure.
The question's are...
a) has any one seen this or similar very low pressure reading before partic. with just key on and engine not running.
b) does any one have the web address for Landrover technical where I can get wiring diagrams and component locations.
I have fitted a new, genuine manifold/boost pressure sensor, reading changed from 15 to 16 kPa. Voltage at sensor plug is 4.9v with zero vaults on other 2 wires. Not too concerned about P140A at the moment.
Any help with the above would be greatly appreciated.
