I've just bought a Freelander Td4 and I can't get the toolbox out. The yellow stopper won't turn by hand. I've given it a go with a pair of long nose pliers but it just turns, and turns, and turns without undoing. In the meantime I've managed to snap most of the lid off so want to replace the whole toolbox (found one on eBay for a bargain 30 quid) but I can't remove the old one. Can anyone help?
Removing boot toolbox
- Thread starter wrd
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shimsteriom
Master Procrastinator
- Posts
- 41,905
- Location
- Over Here
Welcome to LoonyZone 
Hippo
Lord Hippo
- Posts
- 55,525
Welcome to the forum
This section is for introductions only. For technical help you should post your questions in the vehicle specific sections listed below, where owners of those vehicles will offer advice.
Main forum index:
www.landyzone.co.uk/forum
Freelander 1 and 2:
https://www.landyzone.co.uk/forum/land-rover-freelander.9
Defender, 90, 110, 130 (tratters)
https://www.landyzone.co.uk/forum/defender-90-110-130.77
Series 1, 2, 3 (tratters)
https://www.landyzone.co.uk/forum/series-land-rovers.6/
Discovery:
https://www.landyzone.co.uk/forum/land-rover-discovery.8
Range rover:
https://www.landyzone.co.uk/forum/range-rover.10
This section is for introductions only. For technical help you should post your questions in the vehicle specific sections listed below, where owners of those vehicles will offer advice.
Main forum index:
www.landyzone.co.uk/forum
Freelander 1 and 2:
https://www.landyzone.co.uk/forum/land-rover-freelander.9
Defender, 90, 110, 130 (tratters)
https://www.landyzone.co.uk/forum/defender-90-110-130.77
Series 1, 2, 3 (tratters)
https://www.landyzone.co.uk/forum/series-land-rovers.6/
Discovery:
https://www.landyzone.co.uk/forum/land-rover-discovery.8
Range rover:
https://www.landyzone.co.uk/forum/range-rover.10
