M
murph
Guest
It depends on how keen you are to save money, I did my Disco in the carpark
at the back of the house, cost £110 for full system, local rip you off kwick
fit £210, usually the hardest part I removing the old one, just cut it off
and it should be a simple job, plenty of assembly paste round the joints is
always useful.
Murph
"Mr.Nice." <markvarleyphoto@*nospam*softhome.net> wrote in message
news:[email protected]...
> Well my land rover now sounds more butch which can mean only one
> thing... it's time for a new exhaust.
> The whole thing is looking near the end of it's working life and the
> rear section has just parted company with themid section at the join
> with the silencer.
> So, going for a full replacement of a mild steel one, questions are..
> Is this a royal pain in the arse I should take to someone else or is
> it a fair DIY job?
> Remembering I work at the roadside, no workshop here.
>
>
> Regards.
> Mark.(AKA, Mr.Nice.)
> --
> _________________________________________
> www.markvarleyphoto.co.uk
> 1984 110 CSW 2.5(na)D
> (3,000 rivets flying in close formation)
> _________________________________________
>
>
>
>
> ................................................................
> Posted via TITANnews - Uncensored Newsgroups Access
> >>>> at http://www.TitanNews.com <<<<
> -=Every Newsgroup - Anonymous, UNCENSORED, BROADBAND Downloads=-
>
at the back of the house, cost £110 for full system, local rip you off kwick
fit £210, usually the hardest part I removing the old one, just cut it off
and it should be a simple job, plenty of assembly paste round the joints is
always useful.
Murph
"Mr.Nice." <markvarleyphoto@*nospam*softhome.net> wrote in message
news:[email protected]...
> Well my land rover now sounds more butch which can mean only one
> thing... it's time for a new exhaust.
> The whole thing is looking near the end of it's working life and the
> rear section has just parted company with themid section at the join
> with the silencer.
> So, going for a full replacement of a mild steel one, questions are..
> Is this a royal pain in the arse I should take to someone else or is
> it a fair DIY job?
> Remembering I work at the roadside, no workshop here.
>
>
> Regards.
> Mark.(AKA, Mr.Nice.)
> --
> _________________________________________
> www.markvarleyphoto.co.uk
> 1984 110 CSW 2.5(na)D
> (3,000 rivets flying in close formation)
> _________________________________________
>
>
>
>
> ................................................................
> Posted via TITANnews - Uncensored Newsgroups Access
> >>>> at http://www.TitanNews.com <<<<
> -=Every Newsgroup - Anonymous, UNCENSORED, BROADBAND Downloads=-
>