Hi , I'm getting ready to pull out the gearbox and transfer box as a unit from my 300tdi Defender , using an engine crane through the passenger side . Does anyone have any advice on how to attach the sling to get the box to come back as level as possible ? Thanks in advance .
R380 & Transfer Box Balance Point ?
- Thread starter dogdog1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 3,893
Tirran
Well-Known Member
- Posts
- 229
- Location
- South Lanarkshire
Miktdish is correct the transfer box and gearbox will try and rotate left to right.
How do you intend to remove them, from underneath or through the door aperture. Having installed mine when the body was off top down on to the chassis, I would have thought dropping to the floor would be easier, assuming the vehicle is already on ramps/ axle stands.
As Lynall says, it’s messy either way.
How do you intend to remove them, from underneath or through the door aperture. Having installed mine when the body was off top down on to the chassis, I would have thought dropping to the floor would be easier, assuming the vehicle is already on ramps/ axle stands.
As Lynall says, it’s messy either way.
I lowered it onto a trolley .
