R380 Gear Box Issues

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Lurk

Member
Posts
55
Location
High Peak
Looking for some wisdom and recommendations.

When I gave my 110 CSW TD5 2002 reg' defender its first service in Oct' after buying it, I changed all the oils as the service log showed the gearboxes nt been done in a few years. The oil recommended to me at that time was Fuchs Titan Sintofluid SEA 75w-80 by Opie Oils.

Unless I am mistaken, once the engine and gearbox get warm, I find the gear changes far more clunky than when cold. Things progressed today to the point that after around an hours running at 50 -60 mph steady trucking, when I needed to 'drop down' to fourth - it would not engage / was blocked. Bringing things to a halt at a roundabout 1st required a good shove in . Moving up 1-,2-3, 3-4 all ok 4-5 clunky/needed a shove into gear. Parking was 'fun' as reverse was not an easy find again needing a good shove in and feeling gears find places.

What do folks use in there gearbox (link if you get it online much appreciated) - or should I be gritting my teeth for bigger bills. Is this common ?

It seams far less troublesome when trucking around locally lower speeds and mostly short trips.
 
upload_2019-12-8_18-42-54.png
 
It was the Tech' Staff member at Opie Oils - I even have all the dialogue as I few stories about guys using various grades and running into trouble - he assured me that the Fuchs grade was the correct 'equivalent' grade.
The 'manual' - thats handy :) I see Rimmer Brothers offer this:- https://rimmerbros.com/Item--i-STC9157 any one used it ? Is it as described and not a 'near equivalent' ?
 
Back
Top