kevin weeden
Member
- Posts
- 12
- Location
- Kent U.K
Engine removed
LT77 with toyota bellhousing fitted
Toyota 1kz fitted
Toyota engine in
r/rover classic with toyota 1kz
- Thread starter kevin weeden
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Engine removed LT77 with toyota bellhousing fitted Toyota 1kz fitted Toyota engine in
West Slope Rover
Well-Known Member
- Posts
- 8,617
- Location
- deep underground
But now it has a dependable lump. What fun is that?
kevin weeden
Member
- Posts
- 12
- Location
- Kent U.K
Well your right there in a way But there is more to life surely!!
uk_vette
Well-Known Member
- Posts
- 765
- Location
- Warrington, Cheshire
Good conversion I would say.
Perhaps a little underpowered ?
130 bhp
295 tq.
At least, this may be a case for the "hare and the tortoise" race.
Where as normal, the tortoise wins in the long run.
Gra.
Perhaps a little underpowered ?
130 bhp
295 tq.
At least, this may be a case for the "hare and the tortoise" race.
Where as normal, the tortoise wins in the long run.
Gra.
kevin weeden
Member
- Posts
- 12
- Location
- Kent U.K
Pulls harder than the TDI without intercooler With one & slight bit of a pump & charger tweek hits 200bhp with more if wanted But as it is is just fine Good on fuel & very reliable
The Ferkin BoB
Banned
- Posts
- 3,703
- Location
- on a ferkin footpath......
the pistons on that are quite big,i would wind it right up,big intercooler etc.it will take it easy and get the rangie up to speed quickly,
uk_vette
Well-Known Member
- Posts
- 765
- Location
- Warrington, Cheshire
kevin weeden
Member
- Posts
- 12
- Location
- Kent U.K
Have been running Prado with 1kz that is on 180bhp with no probs for 6yrs now & i didnt do much to get that1
