P38 eas problem (typical)

Josiepop93 · Jan 4, 2022

Datatek said:
Cut the connector off and solder to the sensor pins then cover with glue filled heatshrink. Cheaper and quicker than a new harness.

Bearmach offer the harness for about 5 quid so I'm just going to go down that route

Datatek · Jan 4, 2022

Josiepop93 said:
Bearmach offer the harness for about 5 quid so I'm just going to go down that route

Is that just a short piece or the full length to the ECU? If the latter it will be time consuming to fit. Good luck with it.

Mark Piercy · Jan 4, 2022

Josiepop93 said:
Are there connections relating to the eas on the right hand side kick panel aswell? I was unaware! I will have to get those done too then

Not to sure but do them buggers as well

Grrrrrr · Jan 4, 2022

Josiepop93 said:
Well I've finally tracked down the cause.. Re soldered the connectors in the interior and re built the valve block, seemed to be fine for a week, then it rained and it went all messed up again, finally got a rear right sensor fault, pulled the plug from it and found it was corroded, gave it a quick clean and spray with some electrical cleaner and it's working fine again, I shall get a new harness for that corner. Thanks for all the suggestions and at least by rebuilding the valve block and soldering that connectors I've removed possible problem points from the mix

Odd that didn't throw a fault.

P38 eas problem (typical)

Josiepop93

New Member

Datatek

Well-Known Member

Mark Piercy

Well fumbled member....

Grrrrrr

Technician, Bodgit & Scarper Ltd

Similar threads