I think its my starter motor... help???

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

USLandy

New Member
Posts
114
Location
Chicago IL
Been on vacation for a week and got home and started my 300tdi 90 up (not been run for a week) and drove for about 40 min. Turned it off, sat for about 15 min and jumped back in to drive home, would not start. All my dials worked and lights came on, but nothing at all happened when I turned the key.

After a quick push to the closet hill I pushed it down and got it going. Does this sound like a starter motor problem?? Is there anything I should check to see if it maybe is the electrics between, it just seems odd that it started fine and then all of a sudden it doesn't work at all.

Thanks in advance.
 
Been on vacation for a week and got home and started my 300tdi 90 up (not been run for a week) and drove for about 40 min. Turned it off, sat for about 15 min and jumped back in to drive home, would not start. All my dials worked and lights came on, but nothing at all happened when I turned the key.

After a quick push to the closet hill I pushed it down and got it going. Does this sound like a starter motor problem?? Is there anything I should check to see if it maybe is the electrics between, it just seems odd that it started fine and then all of a sudden it doesn't work at all.

Thanks in advance.

I have had a similar problem, It had started fine, driven for 20 minutes, stopped and re-started and nothing happened, the started motor trigger had vibrated off, Its a small female spade terminal, I'm not sure if it's the same as the 300 as mine's a 200, but this could be worth checking
Hope this helps
 
I have had a similar problem, It had started fine, driven for 20 minutes, stopped and re-started and nothing happened, the started motor trigger had vibrated off, Its a small female spade terminal, I'm not sure if it's the same as the 300 as mine's a 200, but this could be worth checking
Hope this helps

I'm about to go under the engine and smack it with a mallet... but where is this terminal located???
 
ERR5009.jpg


The male spade terminal on the solenoid
 
Fixed! I have a left hand drive so the steering shaft was in the way for a good wack with the mallet so I got a piece of 2x4 wood and wedge that up against it and hit the wood with the mallet. Start right up!! happy because I head back to university in a few days, so this saves me time and beer money!
 
Back
Top