Exhaust Back box

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Taffy

Active Member
Posts
470
Location
Wrexham North Wales
Hello and greetings and happy new year to everyone.
couple questions thou.

1. my exhaust backbox has fallen off the pipe from front to the back still there, just missing backbox etc will it be okay to drive 100 miles tomorrow? 50 there and back etc and will get new one in the week anyway. 200tdi disco

2.My disco driver footwell was leaking in water, been searching for while and discovered that my driver door and the frame has a bigger gap then the passager door with frame etc frame pillar is the frontscreen frame etc it is possbile to buy a bigger thicker rubber seal to block out the water when it rains?

regards, Taffy:)
 
my exhaust backbox has fallen off the pipe from front to the back still there, just missing backbox etc will it be okay to drive 100 miles tomorrow? 50 there and back etc and will get new one in the week anyway. 200tdi disco

I drove my 300Tdi Disco for about 1500 miles over a week last year when I pulled the back box off at KORC. Couldn't get a new one until the week, then didn't have time.

No extra noise, indeed I wouldn't have noticed it until someone pointed it out to me ...;)
 
Hello and greetings and happy new year to everyone.
couple questions thou.

1. my exhaust backbox has fallen off the pipe from front to the back still there, just missing backbox etc will it be okay to drive 100 miles tomorrow? 50 there and back etc and will get new one in the week anyway. 200tdi disco

2.My disco driver footwell was leaking in water, been searching for while and discovered that my driver door and the frame has a bigger gap then the passager door with frame etc frame pillar is the frontscreen frame etc it is possbile to buy a bigger thicker rubber seal to block out the water when it rains?

regards, Taffy:)

1. dont worry about the back box....many offroaders took them off anyway..

2. the driver's door could be adjusted for alignment....just did mine on new years day....open door, loosen the torx bolts on the door bracket, adjust the alignment, tighten the torx bolts, close door, check alignment & gaps....and re-do the above till you're satisfied with the work...
 
Back
Top