Disco zf 4 spped

I recently posted a quiz about the lock up clutch on my 300tdi not always
loking up when it should.

I have since replaced the oil, however the H#**es lists the capacity of the
auto box as 9.8l and I drained about 4,5l and replaced the same amount. Thus
there remains about 5 and some change liters of old atf sitting in there.

While I was under there I noticed the a bolt which seemed to be under the
torque converter and I thought it might be a plug to drain same, however,
stupid W/S mannual has no info about plug and only goes are far as
suggesting taking vehicle into your Local Landrover dealer where they can
really bugger it up for you. Thus I did not chance removing the plug.

In my last post someone suggested chaning the atf as a first resort, however
I can now report no major difference in performance. Another poster
suggested that he has more detailed instructions that he could email (about
1.5Mb). If you are still out there could you please send any info you have
to:
steve (at) checkitsystems (dot) com

Much obliged and any other contributions welcome.

Regards'
Stephen

when I booked my Discovery in for the gearbox filter to be changed they
recommended in the two weeks before it was being done I change the gearbox
oil a couple of times as when you drain it about half stays in the torque
convertor.
Richard

"fanie" <[email protected]> wrote in message
news:[email protected]...
> I recently posted a quiz about the lock up clutch on my 300tdi not always
> loking up when it should.
>
> I have since replaced the oil, however the H#**es lists the capacity of
the
> auto box as 9.8l and I drained about 4,5l and replaced the same amount.
Thus
> there remains about 5 and some change liters of old atf sitting in there.
>
> While I was under there I noticed the a bolt which seemed to be under the
> torque converter and I thought it might be a plug to drain same, however,
> stupid W/S mannual has no info about plug and only goes are far as
> suggesting taking vehicle into your Local Landrover dealer where they can
> really bugger it up for you. Thus I did not chance removing the plug.
>
> In my last post someone suggested chaning the atf as a first resort,
however
> I can now report no major difference in performance. Another poster
> suggested that he has more detailed instructions that he could email
(about
> 1.5Mb). If you are still out there could you please send any info you have
> to:
> steve (at) checkitsystems (dot) com
>
> Much obliged and any other contributions welcome.
>
> Regards'
> Stephen
>
>

fanie wrote:

>I recently posted a quiz about the lock up clutch on my 300tdi not always
>loking up when it should.
>
>I have since replaced the oil, however the H#**es lists the capacity of the
>auto box as 9.8l and I drained about 4,5l and replaced the same amount. Thus
>there remains about 5 and some change liters of old atf sitting in there.
>
>While I was under there I noticed the a bolt which seemed to be under the
>torque converter and I thought it might be a plug to drain same, however,
>stupid W/S mannual has no info about plug and only goes are far as
>suggesting taking vehicle into your Local Landrover dealer where they can
>really bugger it up for you. Thus I did not chance removing the plug.
>
>In my last post someone suggested chaning the atf as a first resort, however
>I can now report no major difference in performance. Another poster
>suggested that he has more detailed instructions that he could email (about
>1.5Mb). If you are still out there could you please send any info you have
>to:
> steve (at) checkitsystems (dot) com
>
>Much obliged and any other contributions welcome.
>
>Regards'
>Stephen
>
>
>
>



Your bolt in the torque convertor: Does it seem to be unrelated to any
other series of bolts? Does it have (IIRC) a square rather than hex
head? If so, it'll be the drain plug which, IIRC should only be fitted
whilst wading and should have an adajcent parking point in the same
general area. Assuming that you have it, does the handbook not mention
it? (sorry)

Not sure if this is relevant to the Disco but. . . Referring to the
w/s manual for my 88 RRC and the section for the ZF 4HP 22 gearbox:

The data section specifies 9.1 litres of ATF from dry and goes on to say
that 'when draining oil from the ZF gearbox, oil will remain in the
torque convertor, refill to high level on dipstick only.

What are the symptoms of the direct drive clutch problem? I can copy
the relevant bits of the fauilt finding flow chart for you, but almost
all roads lead to someone who understand autoboxes.

Richard

In <[email protected]> fanie wrote:
> I recently posted a quiz about the lock up clutch on my 300tdi not
> always loking up when it should.
>
> I have since replaced the oil, however the H#**es lists the capacity
> of the auto box as 9.8l and I drained about 4,5l and replaced the same
> amount. Thus there remains about 5 and some change liters of old atf
> sitting in there.

Are you SURE you are checking/refilling to the correct level ?

Low oil level in these boxes will cause a number of strange gearchange
effects. Draining 4.5 lires out suggests you might be short of oil
although some is always retained in the torque convertor ISTR it's
normally about 4 litres.

When you refill the box you should refill it to the high level on the
stick. Then start the engine and put the box into drive, then reverse,
then drive again (repeat this two or three times) then put the box into
neutral (don't forget the hand brake !) and check the level with the
engine still running. The oil level should be between the two marks. In
most cases where you just fill it up to the high mark you'll find that
the oil level has now disappeared off the dipstick altogether and you
need to add another half litre or so to get it back to the correct level.

HTH

cheers

Dave W.
http://www.yorkshireoffroadclub.net/