Hi everyone I have owned a p38 for a few months now, the air suspension was raising as it should most of the time although occasionally very slowly so I checked the compressor seals and they seemed very worn, so I have ordered a seal kit, I reassembled the compressor and went for a drive it auto levelled like normal and seemed to be working fine. Until I came to drive it this morning and it was on it's bump stops! now it will not raise at all I can hear the compressor working, but nothing seems to be happening, any ideas on the problem?
Compressor fault?
- Thread starter P38_Steve
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 58,170
- Location
- Preston Lancs.
See other threads on these problems. I gave an answer on how to check for compressor output/diaphragm failure on a thread yesterday. You did not buy a Dutch seal by any chance did you?
Datatek
Well-Known Member
- Posts
- 46,395
- Location
- Near Poitiers SW France
If you ordered the seal from the Dutch lot Goswin, that is probably the cause. If the compressor is worn it's likely that the airbags are shot and leaking.
