generaldogsbody
Active Member
- Posts
- 389
- Location
- North west england.
Replaced slave cylender this morning,when i took the old one off the push rod was still in place on the clutch fork.Iv'e never done one before so don't know if there should be any play in the rod or how much.Also if you use a pressuerisd bleed kit to bleed the clutch,should it really push the fluid out.It isn't,even when i remove the pipe from master cylender nothing comes out .if you pump the pedal it just spits a little bit.Thanks in advance.PS When the clutch went,the pedal just went down to the floor with no clangs or noise.
