Brake lines

I've got to the point where the new chassis is painted and I'm now looking at installing the new Brake lines. My old chassis is a real hotch potch with the Brake lines bent loosely all over the place and held by zip ties. My question is that the 4 way connector on the old chassis is situated on the bulkhead out rigger support arm (in front of it) and I'm wondering if this is correct. Richards chassis don't give you the holes for your brake line connectors or clips and I've bought a kit with set pipe lengths. I'd prefer to place the connector correctly and then work outwards from there. Any photos, would be appreciated. It's a series 3 single line system with an added aftermarket servo. Thanks!!

My 4 way connector is in the same place.