Bought Multi-Point LPG Kit, advice on fitting please.

Colin from Hull · Jul 19, 2011

Hi, I have bought a engine with LPG Kit, want to fit the kit on my Range Rover 4.0 se, that im driving, i thought i would do the donkey work, then take it to be passed off, so has anybody go any advice on fitting the bits, were to positions the parts,tank goes in wheel well, need some pipe, 8mm and 6mm, does anybody have some proper instruction on this subject, could i test the system for leaks with my compressor, PTFE have been told not to use this! Cheers Colin

klf400 · Jul 20, 2011

Colin from Hull said:
Hi, I have bought a engine with LPG Kit, want to fit the kit on my Range Rover 4.0 se, that im driving, i thought i would do the donkey work, then take it to be passed off, so has anybody go any advice on fitting the bits, were to positions the parts,tank goes in wheel well, need some pipe, 8mm and 6mm, does anybody have some proper instruction on this subject, could i test the system for leaks with my compressor, PTFE have been told not to use this! Cheers Colin

what make is it ? if taken from a doner car where the lpg wiring is spliced to the range rover loom it should be cut so as to leave some of the range rover loom on it so you can trace the colour coded wires , tank normally goes in the spare wheel well
i do have a wiring diagram for prins lpg i could email you
any new bits google tinley tech
Tinley Tech Limited Autogas conversion equipment

liverpool-luke · Jul 20, 2011

post as much info as you can make type tank ect

Colin from Hull · Jul 21, 2011

Hi, Thanks for your replys, but i havent collected the LPG/Kit yet going Sunday for it. I will update asap. Thanks again!!!!!!!!!!! Colin

Bought Multi-Point LPG Kit, advice on fitting please.

Colin from Hull

Active Member

klf400

Active Member

liverpool-luke

New Member

Colin from Hull

Active Member

Similar threads