am I doing something wrong ?

My rear hub oil seal started leaking badly after getting the engine fixed.Usual thing inner bearing had fell apart.So changed seal and both bearings...Fark me done less than 500 miles and the rear seal is ****ing out grease again !
Is it me doing something wrong or do they do this reglear ?

did you seat the seal proper?
did yer fit a noo drive-member gaskit?
did yer over-pack wiv grease?
is yer inner oil seal gone?
is yer axle breeva blocked?
was it a ****part seal?




so many qweshchuns.

Treworgey 90 said:

did you seat the seal proper?
did yer fit a noo drive-member gaskit? yes
did yer over-pack wiv grease? don't think so......
is yer inner oil seal gone? its brand new
is yer axle breeva blocked? better ave a look
was it a ****part seal? yes




so many qweshchuns.

Click to expand...

erm cant understand the seal going again unless the bearing is fooked ?

Disco71 said:

erm cant understand the seal going again unless the bearing is fooked ?

Click to expand...

I can - if it were ****part.

What is the condition of the stub axle that the oil seal runs on?

A little (preferably red rubber) grease on the inner lip of the seal can help until all the bearing grease has been spread around.

Definately check axle breathers. Use geniune seals