2.5 dtse - Still having hot start probs!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
9

999mph

New Member
Posts
48
Have a 1995 2.5dtse with the usual bmw engine. Since i have had it, it has always had the hot start issue. Now dont laugh. but i bought an aftermarket fix of a reputable seller on ebay, device is a 30 second delay relay circuit board, in a housing.

Connected to engine temp sender, 12v supply on starting relay plus an earth. Done this, no joy. Took to my local mechanic who checked it and agrees it is wired right, internal leds on circuit boards are lighting and going out, but it has made no difference. Preheat coil symbols dont light on dash when i do this either.

Some people have said you can adjust belt/chain??? on fuel pump to compensate this problem. Would appreciate words of help from anyone, before i have to buy another new battery!!
 
Hi 999MPH. I just fitted timed fix on my 2.5 BMW engine P38 1997 bought from ebay for approx. £30.00. followed instructions, Great! heater coil lamp comes on starts on first click when goes out. Previously 10/12 secs.(a long embarrasing time) cranking before starting. I have had a battery each year for the last 4 years. Goldpanner
 
thanks goldpanner, sounds like i have the exact same unit as you. When you cut into the engine temp sender wire, the instruction say to cut the blue/grey wire on the wiring loom. The only one i could find had a dark grey stripe which looked almost brown..... Does this sound like the right one or have i screwed up?? The led lights up on the circuit board, could this just be the 12volt signal from the relay only.
 
Hi 999mph. I noticed you said you connected into the BLUE/GREY wire. If you re-read your instructions I think you will find the wire you want is GREY/BLUE ( see Photo) It is a Grey wire with a blue stripe.
I have taken a picture of the wire but do not know how to load it into message. give me your email address & I will send photo. Regards Goldpanner
 
Goldpanner, many thanks for the update, at work tonite but will look at in the morning. Just one question......w3hat the hell have i actually cut into in the wiring loom?????? Time to consult rave for wisdom.
 
:DGoldpanner, glad u read instructions carefully, unlike me. Got the grey blue wire connected and my rangie is going a treat. My battery is also thankful for the rest!!
 
No problems, you can checkout the website www.tawpark4x4.com, which has the ebay link on it, plus photos and full fitting instructions. Learn from my mistakes..... read the instructions carefully!!
 
well, fitted that unit today and it's great to be able to turn on the jeep even when people are near:D:D:D
it now starts on the button every time, heater plug comes on, great:cheer2::rofl:
 
You must log in or register to reply here.

Similar threads

H
P38A 1997 2.5 cranks dont start
Replies
6
Views
1K
Datatek
Datatek
A
No crank no start
Replies
14
Views
2K
Rubberknees
Rubberknees
robbiemcvee
Discovery2 engine light flashing wont start
Replies
11
Views
960
Royston 90
R
D
Freelander won't start
Replies
17
Views
2K
Nodge68
Nodge68
L
L322 Td6 2006 hot start issue
Replies
0
Views
646
Lezley
L
Back
Top