What have you done to your Landie today.

[MoorlandBOB]

drained the rusty water from the transfer box and put oil in instead lol...

 

[THEengineer]

What's up with it???

one nut snapped off the lock stops,my fault,other ones looking fooked as well

 

[robint]

been welding cills again ready for it mot next week

 

[THEengineer]

been welding cills again ready for it mot next week

least your disco dont rust as bad as a transit,just had all the cills on our 03 trannie rebuilt,and theres still loads of welding left underneath it

 

[robint]

least your disco dont rust as bad as a transit,just had all the cills on our 03 trannie rebuilt,and theres still loads of welding left underneath it

wouldnt say that this is the third time and last time being cut off later in the summer

 

[tom1disco.300]

weekly checks,oil,water, and airfilter,tires,steering box oil level,and wheel bearings,brake fluid and clutch fluid,oh and adjusting brakes constantly as they are just crap! haha

 

[landowner]

Tried to fix side lamp on defender but cant figure out the wiring

It has a black earth wire and two others, one is green/purple and the other red, Not like the wiring diagram on rave so left it till Monday

 

[Tomp]

Started on the drop down shelf on the rear door of the disco.

 

[SnowmanV8]

Watched fanatic work out why my dr evil style v8 was well being a dr evil v8

 

[MoorlandBOB]

Watched fanatic work out why my dr evil style v8 was well being a dr evil v8

i personally would have set fire to both.....

 

[gemsdad]

i personally would have set fire to both.....

still got your shed of a tratter then bob?

 

[SnowmanV8]

i personally would have set fire to both.....

Was going to but you didn't show up to throw on top. Every good bonfire needs a gay..... Erm I mean guy

 

[Pikey]

one nut snapped off the lock stops,my fault,other ones looking fooked as well

just replace with noo bolts. if you have to much lock I:E rubbing use longer bolts.

 

[Pikey]

Changed blown bulbs. Do I have to remove dickie seat to get to light cluster?

no just align it so ya can get ya hands in to undo top and bottom retaining knobs. whole cluster can then be removed from outside of vehicle.

 

[Grahame of the shires]

Drove up A1 to drop daughter of at a St Johns Ambulance camp. Then drove home only to be held up for 1/2 hour cos some stupid animals decided to use the road!!!!

 

[rich290185]

Fan belt ordered at lunch time,it came at 2 am i had it fitted by 2:30.
all the oils getting done tomorrow EGR kit ordered and i think ill get a timing kit ordered for next week

 

[Oldseadog]

Fitted me new tunnel boot. It now stops the wind coming up through the hole above the gearbox!

 

[brian47]

just replace with noo bolts. if you have to much lock I:E rubbing use longer bolts.

That's his plan apparently, just as long as he can get the old ones out!

So far he's busted the head off one and turned it into a stud, then he tried my Sealy stud extracter, didn't work so he tried a Stiltson and that didn't work so he tried a bigger Stiltson.

I think he's going to try some intense heat next.

If that fails I reckon he's going to have to drill the old ones out and retap the holes.

And yes, he assures me that he slackened off the lock nuts first.

 

[ebbadger]

decided to do a trial fit of the rangie classic rear seat for the station wagon......

first step was to measure n chop out a 10cm deep cut into the arch...

next I trimmed down the cut out section and riveted it to form a new 'side' panel.....

then I fabricated the missing metalwork from a thick galvanised shelf that I had 'liberated' some time ago..... sealed and riveted all round

then time for a trial fit of the seats.....

fits well at the rear also....

you sit at a far more sensible height... rear passengers can look through the window instead of the alpine lights lol.........


and you still have full folding capability so load space is still fully useable....

cheers steve

 

[HLRSeagull]

Egr valve bypass done , removed valve and replaced top hose ....

New illumination bulb behind heater controls

New wiper blades

Adjusted handbrake up as needed too

And last but not least printed off London to Brighton application form to send off , this will be my first ever run but won't be camping on the Saturday