jane-eliza
New Member
- Posts
- 62
thanks beneagles
have a go at the spots yaself,or get someone to give you a hand,it aint that hard,just make sure you use a relay,i used 1 relay for each pair,so 4 spots =2 relays..wired into main beam but on a seperate switch so i can also switch the spots off and have normal main beam,welcome to the site..then when ive had that done, i want spots putting on the roof. any advice where to go![]()
you can take them in between the window seal then down door pillar ,but got to be carefull,some people drill hole in roof and seal it with rubber gromet,mine i got some flexi pipe sleeving,and ran it down back of the snorle and then took it through the gap i had in my bonnet...i wasnt botherd about it looking major good though,think their might be a section on here,just have a browse,hope this gives you a few ideas and helps...other people on here might be able to point you more in right direction,best regards,nunnyim only a mere female........but dont give up on me...........where do all the wires go, when the spots are on the roof??????
Could it be something you have with fish:hysterically_laughiwhat is dynachip
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!